Boltning - Realistic, Lightning, HYPER - v1.0
精選圖片
推薦反向提示詞
grotesque, awkward, misshapen, distorted, twisted, contorted, unsightly, mangled, lopsided, malformed, asymmetrical, irregular, unnatural, botched, mutilated, repulsive, ghastly, hideous, unappealing, terrible, awful, deformed, frightful, odious, obnoxious, ugly, revolting, disfigured, hateful, repugnant, sickening, vile, detestable, abhorrent, loathsome, contemptible, execrable, poorly drawn hands, repellent, disgusting, bad anatomy, blurry, poorly drawn face, distasteful, abominable, out of frame, tiling, extra limbs, poorly drawn feet, watermark, signature, body out of frame, text, blurred, grainy, cut off, draft, amateur, multiple, gross, weird, uneven, furnishing, decorating, decoration, furniture, poor, low, basic, worst, unprofessional, failure, crayon, oil, label, thousand hands
推薦參數
samplers
steps
cfg
clip skip
resolution
vae
推薦高解析度參數
upscaler
upscale
steps
denoising strength
提示
Using any SDXL Lora with the Hyper version results in blurry pictures.
The HYPER version is very fast and about 60% faster than a normal Boltning with same parameters.
The HYPER version uses only the Euler a sampler - do not use other samplers.
The recommended CFG for HYPER is 1 and recommended steps is 10.
Resolution 832x1216 is great but other resolutions also work well.
版本亮點
- The final version!
- Lots of small fixes and additions.
Using any SDXL Lora with the Hyper version of the model results blurry pictures.
The result of experimenting with Lightning models.
What was born as an experiment became a major project. I continue to work on this model and improve it as much as possible. Even though I didn't believe it would turn out to be anything worthwhile, I was wrong. The model has proven to be very good, especially when it comes to generating highly detailed and pleasing to the eye images. I hope you enjoy what I'm doing.
Our slogan: - You don't have ten fingers on your hand, and Midjourney is quietly crying on the side and jealous.
Version 1.0 - Final. I have done a lot of tests and slightly changed the recommended parameters.
Recommended parameters:
Sampler: DDPM, Euler, DPM++ SDE
CFG: 1.5 - 2
Steps: 10
Resolution: 832x1216 is great but you can use any other, does a great job.
A little bit about the HYPER version:
- This is a very fast model. Despite the fact that it weighs twice as much as a normal Boltning, it is much faster. In my tests with the same parameters it is 60% faster.
- This version is very realistic and detailed despite the fact that it uses the “Euler a” sampler.
- It follows prompt better and handles anatomy better.
- There are no plans for a 16 bit version. Sorry.
Recommended parameters for HYPER version (Not published yet):
Sampler: Euler a - do not use another samplers.
CFG: 1
Steps: 10
Resolution: 832x1216 is great but you can use any other, does a great job.
Prompts can be seen in the demonstration pictures.
Special thanks:
badassdragoon2
And to all users who use my model and create masterpieces
Special thanks to my friend - iwtort for the support
If you like what I do, please subscribe
